|
||||
|
||||
|
||||
|
|
||||
DVI cable
VGA cable
AV cables
cable without plugs
AUX cable
AV cable
B&O audio cable
Multi channel audio cable
Subwoofer audio cable
Turntable audio cable and plugs
Analogue audio distribution and convertion
USB memory stick / SD card
USB serial / parallel port
USB Bluetooth adapter
USB card reader
USB network adapter
USB security
USB switch
USB harddisk cabinet
USB wall plate
Colored ethernet cables
Charging cable
Low voltage DC cable and plug
AV installation wall plates
Cable clips, holders and hooks
Velcro, cable ties, strips and tape
Crimping sleeve
Cable marker
Clicktronic
SUPRA Cables
Goobay
Lindy
QED
B&O cables
|
|||||||
|
B & O compatible adaptor cable based on audio cable in good quality, fitted with gold plated phono plugs and trigger cable fitted with Mini Jack (mono) male connector to use 12V trigger from 3rd party surround / stereo equipment. The cable comes out in an 8-pin DIN female connector that gives the opportunity to pass signals in existing or new Powerlink cables.
The cable is constructed with an internal 12-5 volt step-down for the protection of B & O speakers Powerlink port normally specified for max 5V (2.5V-5V in switched mode) and when you use a cable without internal step-down, you will supply the speaker Powerlink port with 12 Volt, which at worst can go and short circuit the powerlink plug of the speaker. Notice that this adaptor cable takes care of the problems you have when using third-party stereo or surround equipment with a 12V trigger for on / off of external devices with B & O speakers. Note: Some people may experience a humming or hissing sound in their speakers if you connect this trigger cable to certain brands of amplifiers / processors. This is due to the ground connection that is on the mini Jack trigger connector. However, this can be removed using a trigger power adapter . Some active B & O speakers have a standard. line input (RCA RCA 'Line'), which the speaker can trigger on and it is basically also a good solution with a third-party system wich is used for music, but when you use B & O speakers in a surround setup, there is a risk that the speaker switches off during quiet passages in the movie and the speaker then can take a while to start up when there is passages with sound again. The problem with on and off switching does not happen with this trigger cable, since it ensures that the speaker is turned on as long as the amplifier (trigger) is on (remember that the little switch in B & O speaker must be either ' L 'or' R 'depending on whether it is Left or Right speaker). Active B & O speakers which are equipped only with a Powerlink such as BeoLab 2 BeoLab 11 BeoLab 7-1 and BeoLab 7-4 etc. can take advantage of this cable because you dont have the option to use line input on these. Notice: Can be used for all B & O BeoLab speakers with Powerlink, except BeoLab 5 and Beolab 3000/5000 speakers - CAN NOT BE USED FOR BEOLAB 5 AND BEOLAB 3000/5000! Do you need more trigger/DC outputs? If you need trigger / DC outputs on your amp / receiver, you can use the following adaptor in small installations: HQ-ADAP010 and for larger installations you can use AV advance Trigger 1-to-6 splitter adaptor cable. Specifikation: • Stereo version • Goldplated phono male-plug (Audio) • Goldplated MiniJack male-plug (12V Trigger) • 8-pins DIN PowerLink female-plug (Audio + Trigger) • Audiocabel in a godd quality • 12V to 5V Step-down (B&O PowerLink protection) Here you can see how other customers have rated the item with character, and possibly made a review. Average rating (4,9):
 
– Of total 16 ratings
Works flawlessly as promised! Very quick international delivery.
Super stik til at bruge B&O til ekstern anlæg.
Beolab 2500. Triggersignalet får jeg fra en gammel Sony mobiloplader med små 5V :-)
super !!!
|
Since AV-Connection’s start in 2000, we have specialised in producing signal and speaker cables in accordance with customer demands for design, quality and length. We manufacture many cables as an alternative to those included with appliances that use a slightly special connection and are not available from the manufacturer in the desired quality or length. It started with PC-TV cables from S-Video and audio to SCART in different lengths, which were impossible to come by in the early TV-out days. A lot has happened since then, and we always stay updated on what is going on in the new connection types, which means that we always have the latest cable standards available.
Unfortunately, as manufacturers do not make manuals or guides in all languages, we cannot guarantee that a local language manual is included for the item.
- If you are unsure about a manual available in the desired language, just contact us and we will do what we can to help.
|
||||||
  |
||||||
| ALL PRICES ARE INCL. 25% DANISH VAT/TAX | ||||||
| AV-Connection A/S • VAT no.: DK27907547 • Kaervej 71-73 • 6400 Soenderborg • Denmark • Tel. +45 7442 1078 • E-mail: [email protected] | ||||||
TEL. +45 7442 1078 (WEEKDAYS 9-17)
HUGE SELECTION AND LOW PRICES
FAST WORLDWIDE DELIVERY
30 DAYS RETURN POLICY WITH PRICE GUARANTEE
HI-FI STEREO
